In our work, the distance between the exposure spots was varied from 10 to 30 nm. The elongated structures were arranged on a square grid with 500 nm spacing. The elliptical holes are elongated along after etching (Figure 4b). After overgrowing the holes with a GaAs buffer layer, the effective migration of Ga adatoms to As-terminated facets leads to an elongation of the defined structure in the [0 1 1] direction (Figure 4c). Thus, the initial elongation is compensated by the buffer layer growth and the final hole

becomes GW-572016 concentration more symmetric. Hence, the aspect ratio (major axis /minor axis) after buffer layer growth decreases with increasing separation of the two exposure spots. Using this approach, it was possible to reduce the aspect ratio of the final hole from, e.g., 1.26±0.05 to 1.13±0.05 for the 20 s sample. Reducing the aspect ratio is promising due to the alignment of the QDs inside the hole as they align along www.selleckchem.com/products/pf-03084014-pf-3084014.html a chain (Figure 4d) in the direction of the hole elongation, i.e., [0 1 1] [37, 39]. Figure 4 Manipulation of

the aspect ratio by appropiate exposure design. Comparison of the aspect ratio before and after the buffer layer growth. Two dots with a certain distance are exposed to the resist (a) in order to define an elongated structure, see (b). The attachment of GaAs depends strongly on the crystallographic direction leading to an elongated structure perpendicular to the previous one, see (c). This elongation leads to a nucleation of QDs along a chain, see (d), and is therefore undesired. With increasing Selleckchem Sirolimus distance of the two exposure spots,

it is shown in (e) to increase the aspect ratio before the buffer layer growth and therefore decrease the aspect ratio after the buffer layer growth due to the different migration rates. The result of writing ellipses instead of round holes into the resist is shown in Figure 4e. The aspect ratio of the major elliptical axes is given with respect to the separation of the two exposure spots before buffer layer growth (black) and after buffer layer growth (red). As intended and shown in Figure 4, the aspect ratio increases (decreases) with increasing distance of the two exposure spots before the buffer layer growth (after the buffer layer growth). Next, the influence of the aspect ratio on the QD nucleation was investigated. Two samples, dry etched for 10 and 15 s, are compared. With increasing distance between the two exposure spots, the final aspect ratio decreases, while the hole size increases. This effect can be seen for both samples. The differences in hole size between the two samples emerge as mentioned above. Androgen Receptor Antagonist research buy longer-etched holes become larger due to a pullback of the resist near the holes by sputtering from the etching gases (compare Figure 1 where the resist is affected near the holes). Furthermore, the aspect ratios of longer-etched holes are smaller. This might be explained by insufficient optimization of the etching gas parameters.