Table 5 Comparison of MD simulation results with the literature   Hardness (GPa) Young’s modulus (GPa) Case 1 of this study – wet indentation 19.5 to 25.5 194.1 Case 2 of this study – dry indentation 12.7 to 21.7 255.3 MD simulation by Fang et al. [37] 20.4 to 43.4 283.4 to 444.9 MD simulation by Leng et al. [38]

23 N/A Nano-indentation experiment [36] 7.1 to 10 135 Micro-indentation experiment 2.1 [39] 116 to 126 [40] Note that the mechanisms of dislocation development with the presence of imperfections and grain boundaries in nano-indentation processes are investigated selleck inhibitor by numerical approaches in the literature. In this regard, the representative studies cover the typical research topics of dislocation nucleation and defect interactions [41], vacancy formation and migration energy, interstitial formation energy, stacking fault energy [42], coherent twin boundaries and dislocations [43], and the effect of grain boundary on dislocation nucleation and intergranular sliding [44]. In addition, Shi and Verma [27] compared the nano-machining processes of a monocrystalline copper and a polycrystalline copper by MD simulation. The results indicate that the presence of grain boundaries significantly reduces the cutting force and stress accumulation inside the workpiece by up to 40%. However, the focuses of these studies are not about the calculation

of hardness and Young’s Flavopiridol price modulus, and certainly they do not tackle the tribological effects Thymidylate synthase of any liquid. As such, it will be interesting to carry out such investigation on nano-indentation simulation of polycrystalline structures in the near future. Friction along the tool/work interface To investigate the tribological effect of water molecules in nano-indentation, the normal force and friction force distributions along the indenter/work material interface are obtained. As shown in Figure 8,

a thin surface layer of the indenter is considered, and the atoms in this layer are evenly HM781-36B mw divided into eight groups. Each group contains about 450 carbon atoms, and the force acting on each atom group is individually computed. Note that each group is identical, so the groups have the same contact area. As such, the force distributions along the indenter/work material interface are actually equivalent to the stress distributions. Figure 8 Atom grouping for friction analysis along the indenter/work interface. The friction force τ and the normal force σ n acting on each group are calculated by the following equations: (16) (17) where F x and F y are the average horizontal and vertical force components of each group, respectively. The distributions of normal force on the indenter/work interface at the maximum penetration position for cases 1 and 2 are shown in Figure 9. The two curves exhibit similar downward trends with the increase of ‘arc distance to the indenter tip’.