Commercial software NASTRAN is used to perform the eigenvalue ana

Commercial software NASTRAN is used to perform the eigenvalue analysis. The bulkheads completely constrain the in-plane deformation of the cross-section. This leads to changes in the stress–strain relationship of shell elements on the hull. The original relationship is expressed as equation(69) σxσyτxy=E1−ν2[1ν0ν1000(1−ν)/2]εxεyγxy check details Let us consider an element

exposed to tensile loading in the x  -direction. If there is no constraint, the y  -direction strain is induced, the amount of which makes the normal stress zero in the y  -direction. On the other hand, if the bulkheads of the model completely suppress the strain in the y  -direction, an additional normal stress in the x  -direction is induced. It is derived by substituting Eq. (69) into Eq. (70). equation(70) εy={−νεxw/obulkhead0withbulkheadBy

integrating the normal stress in DNA Synthesis inhibitor the x  -direction over the distance from the neutral axis on the cross-section, so-called bending rigidity is obtained as in Eq. (71). The bending rigidity is increased by 1/1−2ν(=1.09)1/1−ν2(=1.09) times when the Poisson ratio is 0.3. Axial rigidity is also calculated in the same manner and the same coefficient is derived. equation(71) M=(11−ν2)EI∂θ∂x Warping distortion of the cross-section is shown in Fig. 8. The bulkheads completely suppress the distortion, and the Saint-Venant torsional modulus becomes equal to the polar moment of inertia. Consequently, the torsional modulus is increased by the bulkheads. Timoshenko beam theory assumes Non-specific serine/threonine protein kinase constant shear stress along the cross-section contour and requires calculation of the effective shear factor. These are calculated based on the classical energy approach as equation(72) Ky=1A∫τsy2tds The shear stress is obtained by the 2-D analysis of the cross-section. The flows of shear stress of the cross-section with and without bulkheads are shown in Fig. 9. The shear stress is constant on the side walls and zero on the top and bottom walls because the bulkheads are very stiff. The stiffness

properties with and without the bulkheads are compared in Table 2. All the rigidities are increased by the bulkhead except warping, and the increments are not negligible. Natural frequencies and mode shapes in dry mode are compared. Table 3 shows that the bulkheads play a role in the torsional rigidity and the assumption about the bulkheads is adequate. Slight differences are found in the higher modes but will vanish if the number of beam elements increases. In this case, the beam model consists of 31 uniform beam elements. Eigenvectors of the 3-D FE model are recalculated at nodes of the beam model and compared to each other. Fig. 10 shows the eigenvectors at the reference axis on the mass center. Here, capital T and R mean translational and rotational displacements, respectively, and subscripts denote the directions of the displacements. The displacements are generalized to make diagonal components of modal mass matrix one.

Comments are closed.